Table of Contents
Advertisement
Triggering the Oscilloscope
Trigger Condition
Click or tap the drop-down button of When to select the desired trigger condition.
•
=: triggers when the channel's data equal the set data value. Click or tap the
input field of Data, and then the "Format" interface is displayed. You can set the
data bit that needs to be operated on. For details, refer to descriptions in
Trigger
•
≠: triggers when the channel's data do not equal to the set data value. Click or
tap the input field of Data, and then the "Format" interface is displayed. You can
set the data bit that needs to be operated on. For details, refer to descriptions in
I2C Trigger
•
>: triggers when the channel's data are greater than the set data value. Click or
tap the input field of Data Min, and then the "Format" interface is displayed. You
can set the lower limit of the data bit. For details, refer to descriptions in
Trigger
•
<: triggers when the channel's data are smaller than the set data value. Click or
tap the input field of Data Max, and then the "Format" interface is displayed.
You can set the upper limit of the data bit. For details, refer to descriptions in
Trigger
•
< >: triggers when the channel's data are smaller than the upper limit of the
data value and greater than the lower limit of the data value. Click or tap the
input field of Data Max and Data Min, and then the "Format" interface is
displayed. You can set the upper limit and lower limit of the data bit. For details,
refer to descriptions in
•
> <: triggers when the channel's data are greater than the upper limit of the
data value and smaller than the lower limit of the data value. Click or tap the
input field of Data Max and Data Min, and then the "Format" interface is
displayed. You can set the upper limit and lower limit of the data bit. For details,
refer to descriptions in
User Width
Click or tap the input field of User Width to set it by using the pop-up numeric
keypad. You can also use the corresponding multipurpose knob to set the value. Its
range is from 4 to 32.
The user width is smaller than or equal to the width.
Width
Click or tap the input field of Width to set it by using the pop-up numeric keypad.
You can also use the corresponding multipurpose knob to set the value. Its range is
from 4 to 32.
HDO4000 User Guide
122
.
.
.
.
I2C Trigger
I2C Trigger
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
.
.
I2C
I2C
I2C
Advertisement
Table of Contents
