Table of Contents
Advertisement
Quick Start
-
The oscilloscope is automatically configured to best display the input signals by
adjusting the vertical scale, horizontal timebase, and trigger mode. To set up
the key, please refer to
-
"RUN" or "STOP". When the oscilloscope is stopped, this key is illuminated in
red.
-
trigger mode to "Single".
-
default settings.
-
the oscilloscope is in "RUN" mode, it continues to display new waveforms.
8. Quick Action Key
Press
setup, measure all, statistics reset, waveform record, or save group. To set up the
key, please refer to
9. Trigger Controls
-
details, please refer to
HDO4000 User Guide
22
is the auto scale key. Press this key to enable the auto scale function.
Auto Config
is the RUN/STOP key. Press the key to set the oscilloscope's run state to
is the key for a single acquisition. Press this key to set the oscilloscope's
is the default setup key. Press this key to restore the oscilloscope's
is the clear key. Press this key to clear all waveform on the display. If
to perform the selected quick action: print screen, save wave, save
Quick Action Settings
is trigger setup key. Press this key to access the Trigger menu. For
Triggering the Oscilloscope
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
.
.
.
Advertisement
Table of Contents
