Table of Contents
Advertisement
-
-
•
Y Cursor
Y cursor is a horizontal solid/dotted line that is used to make vertical
adjustments. It can be used to measure amplitude (the unit is the same as that of
the source channel amplitude).
-
-
You can enable cursor measurements in the following ways.
•
Click or tap the function navigation icon
measurements.
•
Click or tap the Cursors button in the toolbar to enable cursor measurements.
•
Press the front-panel
The measurement results will be displayed in the "Result" bar at the right section of
the screen, as shown in the figure below.
•
AX: indicates the X value at Cursor A.
•
AY: indicates the Y value at Cursor A.
•
BX: indicates the X value at Cursor B.
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
Cursor A is a vertical solid line (
and Cursor B is a vertical dotted line (
screen).
In the XY cursor mode, X cursor is used to measure the waveform
amplitude of CH1.
Cursor A is a horizontal solid line (
the screen), and Cursor B is a horizontal dotted line (
right section of the screen).
In the XY cursor mode, Y cursor is used to measure the waveform amplitude
of CH2.
key to enable cursor measurements.
is displayed at the bottom of the screen),
is displayed at the bottom of the
is displayed at the right section of
is displayed at the
> Cursors to enable cursor
Measurements
HDO4000 User Guide
163
Advertisement
Table of Contents
