Table of Contents
Advertisement
Measurements
10
Measurements
You can enter the Measure menu in the following ways:
•
Click or tap the function navigation icon
screen, and then select Measure to enter the "Measure" menu.
•
Press the front-panel
•
Click or tap the Measure button in the toolbar to enter the "Measure" menu.
Vertical System
•
In
menu.
10.1
Measurement Parameter
This oscilloscope allows you to set the measurement source, enable or disable the all
measurement function, the statistical function, and etc. You can make quick
measurements for many waveform parameters. The measurement results will be
displayed in the Result sidebar at the right section of the screen.
TIP
If there is no signal input for the current source or the measurement result is not within the
valid range (too large or too small), then the measurement results are invalid, and "*****" is
displayed on the screen. Please re-input the signal or set the signal.
HDO4000 User Guide
148
key to enter the "Measure" menu.
menu, click or tap the Measure button to enter the "Measure"
Copyright ©RIGOL TECHNOLOGIES CO., LTD. All rights reserved.
at the lower-left corner of the
Advertisement
Table of Contents
