Otto Bock Kenevo 3C60 Introduction Manual page 83

Component selection
Kenevo Protective Cover – Shortening
1 2
•
•
Shorten the
Measure length
Cover along the
from center of
bottom edge of
knee to lower
the mark using a
edge of the
vibration or band
tube adapter
saw
and mark
measured
Carry out a function test with the user wearing
length at 3
the Protective Cover. Cover and prosthetic foot
places all
must not collide. If the Cover collides with the
around the
prosthetic foot, shorten the Protective Cover
Cover
again.
3
•
Remove profile rib
on the interior of the
Protective Cover
Component selection | Kenevo 3C60 | Prosthetic | Global Academy | 22.11.2020
4 5
• •
Install the Fit the distal cap to
Cover. Ensure the distal end of
that all retainers the Cover. Align
and closures the lengthwise
are properly grooves in the
engaged and/or extension of the
fastened. lengthwise closure
on the dorsal side
of the Protective
Cover.
see
manual
| © Ottobock 83