Alignment and adjustment
Flexion stops
Do not insert screws without flexion stops!
•
When delivered the Kenevo is equipped with the 4H107
flexion stops (= 8° less flexion angle)
→
optional 4H108 flexion stops with 16° are available
•
With the stops installed, the maximum flexion angle is:
•
117° with 8° flexion stops (4H107)
•
109°with 16° flexion stops (4H108)
•
Insert both flexion stops (to the left and right of the
piston rod) (TX10 Torx bit)
•
When assembling tighten the screws to 0.6 Nm (torque
wrench 710D21) and secure the screws with thread
lock (636K13)
Alignment and adjustment | Kenevo 3C60 | Prothetik | Global Academy | 12.12.2016
| © Ottobock
112