Otto Bock Kenevo 3C60 Introduction Manual page 142

User instructions
Charging process
•
Connect the inductive charger with the Kenevo (magnetic
connection) and the power supply with the wall socket (charging is
only possible at temperatures between 5°C and 40°C (41°F –
104°F))
•
Inductive charger must be positioned flat and there must be no
foreign particles between both charging surfaces
•
Check the charging status via the color and the illuminating
behavior of the LED on the charger:
→
The faster the yellow LED blinks, the lower is the battery status
→
When the LED shines permanently green, the battery is
completely charged
•
After removing the charger, the knee joint performs a self-test
(keep the knee joint at rest – otherwise an error could be detected)
•
A single vibration and beep signal indicates that the knee joint is
ready for operation (3x beeping usually indicates an exceeded
service interval)
User Instructions | Kenevo 3C60 | Prosthetic | Global Academy | 29.01.2019 | © Ottobock 142