Mounting Instructions For The Adaptation Of The "E-Support" To The Avantgarde Sl, V, Tr, Or D; Description; Mouting Versions - Otto Bock e-support Instructions For Use Manual

Mounting Instructions for the Adaptation of the
"E-Support" to the Avantgarde SL, V, TR, or D
492E24=00000 E-Support (low amplification)
492E24=10000 E-Support (high amplification)

1. Description

The adaptation has been designed to allow assembly of the servo-assisted
"E-Support" to the Avantgarde SL, V, TR or D wheelchairs for active use.
In dependency of the side panels used with the wheelchair, there are two versions
for mounting the adapter to the wheelchair.
2. Mounting Versions:
15 mm
2.1 Side Panel with Height Adjustable Armrest
To obtain a sufficient distance between side panel and rear wheel, mount the
adapter plate to the outside of the wheelchair.
1
It is necessary to check and possibly readjust the position of the fitting in the
adapter plate. The height of the fitting in relation to the adapter plate is
15 mm. T he Nordlock washers are mounted to the inside.
2
With this version, on each rear wheel of the "E-Support" two spacers are
screwed one after the other into the threaded bore shown in figure 3.
Thread for
spacer
3
31