Table of Contents
Advertisement
7 HANDLEBAR,CONTROLS
7.1
7.2
50
Handlebar �osition
800116-10
Adjusting the handlebar �osition
B00375-10
On the upper triple clamp, there are two holes at a distance
of
to each other.
6)
I Hole distance A
5 mm (0.59 in)
11
The holes on the handlebar support are placed at a distance
0
of
from the center.
I
I Hole distance B
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. In this
way, the handlebar can be mounted in the most comfortable
position for the rider.
-
O.
Remove screws
Take off the handlebar clamps. Take off
the handlebar and lay it to one side.
Info
Protect the components against damage by covering
them.
Do not bend the cables and lines.
-
8.
Remove screws
Remove the handlebar supports.
-
Place the handlebar supports in the required position. Mount
8.
and tighten screws
Guideline
Screw, handle-
M10
bar support
•
Info
I
Position the left and right handlebar supports evenly.
-
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor
rectly.
-
Position the handlebar clamps. Mount and tighten screws
evenly.
Guideline
Screw, handlebar
clamp
40 Nm (29.5 lbf ft)
Loctite
20 Nm (14.8 lbf ft)
MB
®
243
™
0
..
Advertisement
Table of Contents
