Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
36
-
Place the special tool onto the piston rod.
I Mounting sleeve (T14029)
-
Grease seal ring @ and slide onto the piston rod with the
open side forward. Remove the special tool.
I Lubricant (T14034)
-
Slide screw sleeve@) onto the piston rod.
-
Press the seal ring flush into the screw sleeve.
-
Grease the O-ring of the screw sleeve.
I Lubricant (T158)
-
Tighten the screw sleeve.
Guideline
Screw sleeve
on the cartridge
200883-10
-
Mount filling screw
200845-11
-
Clamp the cartridge vertically and fill with fork oil to lower
f)
edge
of the upper part of the cartridge.
I Fork oil (SAE 4) (48601166S1)
✓ The piston rod is fully extended.
-
Mount the screw cap with the membrane holder and tighten
with the special tool.
Guideline
Screw cap on the
cartridge
I Pin wrench (T103)
-
Bleed and fill the cartridge.
-
Fill the cartridge with nitrogen.
200850-10
(I!\;!
p. 307)
(I!\;!
p. 288)
(I!\;!
p. 288)
M24x1
40 Nm (29.5 lbf ft)
@)
with the O-ring.
(I!\;!
p. 286)
M41x1
30 Nm (22.1 lbf ft)
(a
p. 303)
(a
p. 41)
(a
p. 43)
®
Loctite
241
Advertisement
Table of Contents
