Assembling The Piston Rod - Husqvarna FS 450 2016 Repair Manual

Assembling the �iston rod
Info
The steps are identical for both fork legs.
200862-11
-
Mount rebound damping washer
(D
-
Mount spring with the tighter coil at the bottom.
-
Mount and tighten new nut @ with the collar facing down-
ward.
Guideline
Nut, compression
piston
✓ The collar centers the rebound washer and the spring.
-
Check the freedom of movement of the rebound washer
against the spring.
-
Secure the nut by locking.
-
Mount and grease O-ring @.
I
Lubricant (T158) (� p. 288)
-
Clamp the screw cap with the membrane holder and the spe­
cial tool into a vise.
I
Pin wrench (T1 03) (I!\:,!! p. 303)
• Info
I
Only tighten the vise lightly.
-
Mount membrane@).
-
Mount and tighten compression holder �.
Guideline
Compression M9x1
holder
-
Unclamp the special tool.
-
Mount and grease the O-rings of tap rebound
valve.
I
Lubricant (T158) (I!\:,!! p. 288)
-
Position the valve with the spring in the tap rebound.
6 FORK, TRIPLE CLAMP
0.
M6x0.5 3 Nm (2.2 lbf ft)
8 Nm (5.9 lbf ft}
Loctite
O
and the
®
241
33