Table of Contents
Advertisement
18.4
Adjusting the antihog�ing clutch
Warning
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
The characteristics of the antihopping clutch can be affected by the spring preload force.
Increasing the spring preload force causes the clutch to open later when braking (more engine brak
ing effect). The clutch also engages differently when starting; the differences are considerably less pro
nounced than when braking. The clutch then behaves somewhat more aggressively.
In case of a high level of engine braking effect, short-term slip of
the clutch occurs. This prevents rear wheel hopping.
Hazardous substances cause environmental damage.
Preparatory work
-
Place the motorcycle on its left side with the aid of an assis
tant.
Main work
-
Detach spring
Remove screws
-
Remove screw
•
Info
I
Never remove more than one screw at once.
-
Position the required washer.
Guideline
Low preload, without
washer
Moderate preload, with
washer (condition at deliv-
ery)
High preload, with washer
-
Mount and tighten screw
Guideline
Screw, clutch spring
retainer
-
Repeat the procedure with screws (D, @, and
M01377-10
Info
The spring preload must be the same on all screws.
O.
fD
8.
C,.
and
Take off the clutch cover.
0.
0 mm (0 in)
1 .0 mm (0.039 in)
1 .5 mm (0.059 in)
0.
M5
8 Nm (5.9 lbf ft}
18 CLUTCH
@).
243
Advertisement
Table of Contents
