Changing The Engine Oil And Oil Filter, Cleaning The Oil Screens - Husqvarna FS 450 2016 Repair Manual

20 LUBRICATION SYSTEM
250

Changing the engine oil and oil filter, cleaning the oil screens

Warning
Danger of scalding Engine and gear oil get very hot when the motorcycle is ridden.
-
Wear suitable protective clothing and safety gloves.
-
In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Hazardous substances cause environmental damage.
Environmental hazard
-
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
Check the O-rings for damage.
Replace damaged O-rings.
Drain the engine oil while the engine is at operating temperature.
Condition
The engine is at operating temperature.
-
Check the engine oil level.
Info
After switching off the engine, wait one minute
before checking the level.
The engine oil level is between the middle of the level
viewer fj and the upper edge of the level viewer
If the engine oil does not reach the middle of level
viewer fj :
-
Add engine oil.
Preparatory work
-
Park the motorcycle on a level surface.
Main work
-
Place a suitable container under the engine.
O
-
Remove oil drain plug
(� p. 253)
with the magnet and seal ring.
G).
411