7 Handlebar,Controls; Handlebar Position; Adjusting The Handlebar Position - Husqvarna FS 450 2019 Repair Manual

7 HANDLEBAR,CONTROLS

7.1
7.2
46
Handlebar �osition
800116-10
Ad"usting the handlebar osition
B00375-10
On the upper triple clamp, there are 2 holes at a distance of
to each other.
I Hole distance A 15 mm (0.59 in)
1
The holes on the handlebar supports are placed at a distance
of G) from the center.
I I
Hole distance B 3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
Preparatory work
-
Remove the handlebar cushion.
Main work
-
O.
Remove screws Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam­
age.
Do not kink the cables and lines.
-
Remove screws@. Take off the handlebar supports.
-
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
-
Mount and tighten screws
Guideline
Screw, handle- M10
bar support
-
Position handlebar.
Info
Make sure the cables and wiring are positioned cor­
rectly.
-
Position handlebar clamps.
-
O
Mount screws but do not tighten yet.
-
First bolt the handlebar clamps with screws
longer, higher side of the handlebar supports so that both
parts touch.
Guideline
Screw, handlebar
clamp
8.
40 Nm (29.5 lbf ft)
Loctite
O
onto the
20 Nm (14.8 lbf ft)
MB
6)
®
243
™