Adjusting The Steering Head Bearing; Play - Husqvarna FS 450 2016 Repair Manual

6.31 Adjusting the steering head bearing Ria�
-
Install the start number plate.
-
Install the front wheel. (!!:!l
-
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
-
Check the steering head bearing play.
-
Remove the motorcycle from the lift stand.
Preparatory work
-
Raise the motorcycle with a lift stand.
-
Remove the handlebar cushion.
Main work
O.
-
Loosen screws
Remove screw @ .
-
Loosen and retighten screw
Guideline
Screw, top steering
head
-
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
-
Mount and tighten screw @ .
Guideline
M8
Screw, top
steering stem
O.
-
Tighten screws
Guideline
Screw, top triple
clamp
-
Check the steering head bearing play.
Finishing work
-
Mount the handlebar cushion.
-
Remove the motorcycle from the lift stand.
6 FORK, TRIPLE CLAMP
(!!:!l p. 115)
p. 120)
(!!:!l p. 47)
(!!:!l p. 12)
(� p. 12)
fD.
M20x1 .5 12 Nm (8.9 lbf ft)
20 Nm (14.8 lbf ft)
Loctite
M8 17 Nm (12.5 lbf ft)
(!!.,!I p. 47)
(!!.,!I p. 12)
®
243
™
49