7 Handlebar,Controls; Handlebar Position; Adjusting The Handlebar Position - Husqvarna FC 450 2018 Repair Manual

7 HANDLEBAR,CONTROLS

7.1
46
Handlebar �osition
H01188-10
Ad"usting the handlebar �osition
Warning
A repaired handlebar poses a safety risk.
Danger of accidents
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
-
Change the handlebar if the handlebar is damaged or bent.
e-e
0----- - t, e----e
� 0
0
H01189-10
The holes on the handlebar supports are placed at a distance
6)
of from the center.
I I
Hole distance A 3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
Preparatory work
-
Remove the handlebar cushion.
Main work
O.
-
Remove screws Take off the handlebar clamp. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam­
age.
Do not kink the cables and lines.
8.
-
Remove screws Take off handlebar supports@).
-
Position rubber bushings
below.
-
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
-
Mount and tighten screws
Guideline
Screw, handle- M10
bar support
-
Position the handlebar.
• Info
I
Make sure the cables and wiring are positioned cor­
rectly.
-
Position the handlebar clamp.
O
-
Mount screws but do not tighten yet.
8 0
and push through nuts
8.
40 Nm (29.5 lbf ft)
®
Loctite
from
243
™