Table of Contents
Advertisement
26.1
Cleaning the motorc}!cle
Note
Material damage
Components become damaged or destroyed if a pressure cleaner is used incorrectly.
The high pressure forces water into the electrical components, connectors, throttle cables, and bearings, etc.
Pressure which is too high causes malfunctions and destroys components.
Do not direct the water jet directly on to electrical components, connectors, throttle cables or bearings.
Maintain a minimum distance between the nozzle of the pressure cleaner and the component.
Minimum clearance
Warning
Environmental hazard
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance
with the applicable regulations.
Info
If you clean the motorcycle regularly, its value and appearance will be maintained over a long period.
Avoid direct sunshine on the motorcycle during cleaning.
1/111111111111111\\
26 CLEANING/PROTECTIVE TREATMENT
60 cm (23.6 in)
Hazardous substances cause environmental damage.
Close off the exhaust system to prevent water from entering.
First remove coarse dirt particles with a gentle spray of water.
Spray very dirty areas with a normal motorcycle cleaner and
then clean with a paintbrush.
Info
Use warm water containing normal motorcycle cleaner
and a soft sponge.
Never apply motorcycle cleaner to the dry vehicle;
401061-01
always rinse with water first.
After rinsing the motorcycle with a gentle spray of water,
allow it to dry thoroughly.
Remove the plug from the exhaust system.
Warning
Danger of accidents
brake system.
Brake carefully several times to dry out and
remove dirt from the brake linings and the brake
discs.
After cleaning, ride a short distance until the engine reaches
operating temperature.
•
Info
I
The heat produced causes water at inaccessible loca
tions in the engine and the brake system to evaporate.
After the motorcycle has cooled off, lubricate all moving parts
and bearings.
Clean the chain.
Moisture and dirt impair the
(0
p. 130)
273
Advertisement
Table of Contents
