Table of Contents
Advertisement
12
Main work
-
Check the throttle cable routing.
-
Position the fuel tank and fit the two spoilers to the sides of
the radiator bracket.
-
Make sure that no cables or throttle cables are trapped or
damaged.
-
Attach the hose to the fuel tank breather on the tank lid.
-
Mount and tighten screw
Guideline
Remaining screws,
chassis
-
Mount and tighten screws@}.
Guideline
Remaining screws,
chassis
fD
-
Plug in connector
for the fuel pump.
-
Remove the wash cap set and thoroughly clean the plug-in
connection of the fuel line using compressed air.
Info
Under no circumstances should dirt enter into the fuel
line. Dirt in the fuel line clogs the injection valve!
-
Lubricate the O-ring and connect plug-in connection
the fuel line.
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
-
Mount the seat.
(a
p. 102)
-
Install the air filter box cover.
-
Install the right side cover.
FUEL TANK, SEAT, TRIM
(l!!ll
p. 51)
O
with the rubber bushing.
M6
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
M6
(a
p. 97)
(l!!ll
p. 101)
8
for
105
Advertisement
Table of Contents
