Table of Contents
Advertisement
6 FORK, TRIPLE CLAMP
46
-
Tighten screws (3.
Guideline
Screw, bottom triple
clamp
C,.
Tighten screw
Guideline
Screw, top steering
head
-
Mount and tighten screw@.
Guideline
Screw, top
M8
steering stem
-
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
-
Tighten screws@).
Guideline
Screw, top triple
clamp
-
Secure the wiring harness left and right with cable
holders@).
-
Mount the holder with Fl warning lamp.
Guideline
Remaining screws,
chassis
-
Position brake line and bracket on fork protector, and mount
and tighten screws.
Finishing work
-
Mount the handlebar cushion.
-
Install front fender.
(a
p. 114)
-
Install the start number plate.
-
Install the front wheel.
(a
-
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
-
Check the steering head bearing play.
12 Nm (8.9 lbf ft)
M8
M20x1.5
12 Nm (8.9 lbf ft)
20 Nm (14.8 lbf ft)
Loctite
M8
17 Nm (12.5 lbf ft)
M6
10 Nm (7.4 lbf ft)
(a
p. 115)
p. 120)
(a
p. 47)
®
243
™
Advertisement
Table of Contents
