Handlebar,Controls; Handlebar Position; Adjusting The Handlebar Position; Adjusting The Basic Position Of The Clutch Lever - Husqvarna FC 350 2014 Repair Manual

HANDLEBAR,CONTROLS

7
7.1 Handlebar osition
7.2 Ad"ustin the handlebar osition
7.3
On the upper triple clamp, there are two holes at a distance of
I Hole distance A
The holes on the handlebar support are placed at a distance of
I Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the most comfortable position for the rider.
800116-10
-
Remove screws
lay it to one side.
• Info
I
Protect the components against damage by covering them.
Do not bend the cables and lines.
-
Remove screws
-
Place the handlebar supports in the required position. Mount and tighten
8-
screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
-
Position the handlebar.
• Info
I
Make sure the cables and wiring are positioned correctly.
-
Position the handlebar clamps. Mount and tighten screws
Guideline
I
Screw, handlebar clamp
-
Adjust the basic setting of the clutch lever to your hand size by turning adjusting
O.
screw
• Info
I
Turn the adjusting screw counterclockwise to decrease the distance
between the clutch lever and the handlebar.
Turn the adjusting screw clockwise to increase the distance between the
clutch lever and the handlebar.
The range of adjustment is limited.
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
15 mm (0.59 in)
1
I 3.5 mm (0.138 in)
O.
Take off the handlebar clamps. Take off the handlebar and
8.
Remove the handlebar supports.
M10
to each other.
f)
0
from the center.
40 Nm
Loctite ® 243
(29.5 lbf ft)
O
evenly.
I
20 Nm (14.8 lbf ft)
42
™
I