Table of Contents
Advertisement
Info
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
-
Move the brake fluid reservoir mounted on the handlebar to a
horizontal position.
-
Cover the painted parts.
O.
-
Remove screws
8
-
Remove cover
with the membrane.
-
Draw the old brake fluid out of the brake fluid reservoir using
a syringe and fill with fresh brake fluid.
Syringe (50329050000)
Brake fluid DOT 4
(�
p. 286)
CD.
-
Mount bleeder cover
I
Bleeder cover (00029013002)
-
Connect the bleeding device.
I
Bleeding device (00029013100)
8-
-
Open shut-off valve
Info
Follow the operating instructions of the bleeding
device.
-
Ensure that the filling pressure is set on pressure gauge f).
Adjust the filling pressure on pressure regulator
sary.
I
Guideline
Filling pressure
0
-
Pull off protection cap
Connect the hose of the bleeder bottle.
I
Bleeding device (00029013100)
-
Open bleeder screw Q) by approx. one-half turn.
Info
Drain until the fresh brake fluid emerges from the hose
of the bleeder bottle without bubbles.
-
Tighten the bleeder screw.
8.
-
Close shut-off valve
-
Open the bleeder screw again until brake fluid stops emerg-
ing.
16
BRAKE SYSTEM
(�
p. 293)
(0
p. 290)
(�
p. 290)
@)
if neces
I
2 ... 2.5 bar (29 ... 36 psi)
of the brake caliper bleeder screw.
(0
p. 290)
147
Advertisement
Table of Contents
