Hand Brake Lever - Husqvarna FS 450 2016 Repair Manual

16 BRAKE SYSTEM
144
Adjusting the basic �osition of the hand brake lever
-
Position the brake caliper. Mount screws
8
ers but do not tighten yet.
✓ The brake linings are correctly positioned.
-
Operate the hand brake lever repeatedly until the brake lin­
ings are in contact with the brake disc and there is a pressure
point. Fix the hand brake lever in the activated position.
✓ The brake caliper straightens.
Q.
-
Tighten screws
Guideline
Screw, front M10x1 .25
brake caliper
-
Remove the locking piece of the hand brake lever.
-
Fill brake fluid up to the MAX marking.
I Brake fluid DOT 4 (� p. 286)
C,
-
Position cover with membrane
screws@).
Info
Clean up overflowed or spilled brake fluid immediately
with water.
-
Adjust the basic position of the hand brake lever to your hand
size by turning adjusting wheel
Info
Push the hand brake lever forward and turn the
adjusting wheel.
Turn the adjusting wheel clockwise to increase the
distance between the hand brake lever and the han­
dlebar.
Turn the adjusting wheel counterclockwise to
decrease the distance between the hand brake lever
and the handlebar.
The range of adjustment is limited.
Only turn the adjusting wheel by hand; do not use
force.
Do not make any adjustments while riding.
O
with wash­
45 Nm (33.2 lbf ft)
®
Loctite 243
™
0.
Mount and tighten
Q.
..
..