7 HANDLEBAR,CONTROLS
7.1
7.2
46
Handlebar �osition
800116-10
Ad"usting the handlebar osition
B00375-10
On the upper triple clamp, there are 2 holes at a distance of
to each other.
I Hole distance A
15 mm (0.59 in)
1
The holes on the handlebar supports are placed at a distance
of G) from the center.
I
I
Hole distance B
3.5 mm (0.138 in)
The handlebar can be mounted in four different positions. This
allows the handlebar to be mounted in the most comfortable
position for the rider.
Preparatory work
-
Remove the handlebar cushion.
Main work
-
O.
Remove screws
Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam
age.
Do not kink the cables and lines.
-
Remove screws@. Take off the handlebar supports.
-
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
-
Mount and tighten screws
Guideline
Screw, handle-
M10
bar support
-
Position handlebar.
Info
Make sure the cables and wiring are positioned cor
rectly.
-
Position handlebar clamps.
-
O
Mount screws
but do not tighten yet.
-
First bolt the handlebar clamps with screws
longer, higher side of the handlebar supports so that both
parts touch.
Guideline
Screw, handlebar
clamp
8.
40 Nm (29.5 lbf ft)
Loctite
O
onto the
20 Nm (14.8 lbf ft)
MB
6)
®
243
™