Table of Contents
Advertisement
7.1
Handlebar �osition
Adjusting the handlebar position
Warning
Danger of accidents
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a
result.
-
Change the handlebar if the handlebar is damaged or bent.
On the upper triple clamp, there are two holes at a distance
6)
of
to each other.
I
Hole distance
The holes on the handlebar supports are placed at a distance
0
of
from the center.
I
Hole distance
The handlebar supports can be mounted in four different posi
tions.
101859-10
A repaired handlebar poses a safety risk.
-
Remove screws
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam
age.
Do not bend the cables and lines.
-
Remove screws
-
Place the handlebar supports in the required position. Mount
101860-10
and tighten screws
Guideline
Info
Position the left and right handlebar holders evenly.
-
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor
rectly.
-
Position the handlebar clamps. Mount and tighten screws
evenly.
Guideline
Screw, handlebar
clamp
7 HANDLEBAR,CONTROLS
e
1 15 mm (0.59 in)
0
I 3.5 mm (0.138 in)
O.
Take off the handlebar clamps. Take off
8.
Take off the handlebar supports.
8.
M10
40 Nm (29.5 lbf ft)
MB
®
Loctite
243
™
0
20 Nm (14.8 lbf ft)
41
Advertisement
Table of Contents
