Table of Contents
Advertisement
7 HANDLEBAR,CONTROLS
7.1
7.2
42
Handlebar �osition
102144-10
Ad"usting the handlebar �osition
e--e
e------e
0------�
0
<U>
102145-10
The holes on the handlebar support are placed at a distance
6)
of
from the center.
I
I
Hole distance A
3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. In this
way, the handlebar can be mounted in the most comfortable
position for the rider.
Preparatory work
-
Remove the handlebar cushion.
Main work
0-
-
Remove screws
Take off the handlebar clamps. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam
age.
Do not kink the cables and lines.
-
Remove screws fj. Remove handlebar support@).
-
Position rubber bushings
below.
-
Place the handlebar support in the required position. Mount
8.
and tighten screws
Guideline
Screw, handle-
M10
bar support
-
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor
rectly.
-
Position the handlebar clamps. Mount screws
handlebar clamps so that both parts touch at the front and
tighten all of the screws equally.
Guideline
Screw, handlebar
clamp
Finishing work
-
Mount the handlebar cushion.
8
and push through nuts
40 Nm (29.5 lbf ft)
Loctite
O.
Screw the
MB
20 Nm (14.8 lbf ft)
@)
from
®
243
™
..
Advertisement
Table of Contents
