Table of Contents
Advertisement
Bleeding and filling the cartridge
Info
Before working with the vacuum pump, carefully read the vacuum pump operating manual.
Alternative 2
Warning
Danger of accident
pension setting may seriously alter the handling
characteristic.
Extreme modifications to the suspension setting
may cause a serious deterioration in the handling
characteristic and overload components.
-
Only make adjustments within the recom
mended range.
-
Ride slowly to start with after making
adjustments to get the feel of the new
handling characteristic.
-
Turn the adjusting screws to the position they were in
before dismantling.
48.
-
Mount protection cap
-
Clamp the cartridge as shown in the figure.
I
Guideline
Use soft jaws.
•
Info
I
Clamp the cartridge only lightly.
The filling port must be located at the highest point.
During the filling procedure, the cartridge must be
lower than the oil tank of the vacuum pump.
The piston rod moves in and out during filling; do not
immobilize it by holding it with your hand.
-
Remove the screw of the filling port.
O
-
Mount special tool
on the cartridge.
I
Filling adapter (T14030)
•
Info
I
Hand-tighten only without using a tool.
8
-
Connect adapter
to special tool
6 FORK, TRIPLE CLAMP
Modifications to the sus
(0
p. 308)
0-
..
41
Advertisement
Table of Contents
