Filling The Cartridge With Nitrogen - Husqvarna FS 450 2016 Repair Manual

Guideline
0 bar
✓ The vacuum pump is switched off.
-
Disconnect the vacuum pump. Remove the special tool.
Info
•
I
The filling port must be positioned at the highest point.
-
Mount and tighten the filling screw with the O-ring.
Guideline
Cartridge filling
screw
200889-10
e with nitro en
-
Clamp the cartridge in a vise using soft jaws.
Info
Clamp the cartridge only lightly.
-
Connect the connector of the special tool to the pressure
regulator of the nitrogen bottle.
Filling tool (T14019)
Filling gas - nitrogen
-
Adjust the pressure regulator of the nitrogen bottle.
Guideline
I
Gas pressure
-
Pierce the membrane with the needle of the special tool.
O.
-
Open valve
-
Fill the cartridge for at least 15 seconds.
I Guideline
Gas pressure
Info
Watch the pressure regulator dial.
Ensure that the cartridge is filled to the specified pres­
sure.
-
Close the valve.
-
Close the nitrogen bottle.
-
Remove the special tool.
6 FORK, TRIPLE CLAMP
2 Nm (1 .5 lbf ft)
M4x0.5
(� p. 306)
1 1 .2 bar (17 psi)
1 1 .2 bar (17 psi)
43