Using Auto Dial Out To Report Fatal Errors - AGFA SelectSet Avantra Series Operating Manual

Using Auto Dial Out to Report Fatal Errors

You can program an Avantra imagesetter to automatically dial out
through its internal modem when it detects a fatal error. The Auto
Dial Out button in the Configuration screen lets you turn this feature
on and off.
The icon button shows the current auto dial out mode.
Auto dial out on.
Auto dial out off.
When Auto Dial Out is on, the imagesetter follows this sequence when
it detects a fatal error:
1. The imagesetter detects an error and displays the appropriate icon
on the control panel.
2. After a four-second delay, the imagesetter automatically reboots.
3. When the software detects the fatal error during the reboot, it
automatically dials out to report the error to the remote diagnostic
computer. When the modem connects, the service communication
icon appears:
Note: Do not shut off the system while dialing out or communicat-
ing with the Remote Diagnostics Center or an incomplete report
will be sent.
Using the Imagesetter Control Panel 2–57