Table of Contents
Advertisement
2–54
SelectSet Avantra Series Control Panel and Operating Guide
Definition of Configuration Functions
Image Mode: Use this function to select the image mode as follows:
Positive Right Reading:
Type and images exposed; background unexposed.
Right reading with the media emulsion side up.
Positive Wrong Reading:
Type and images exposed; background unexposed.
Right reading with the media emulsion side down.
Negative Right Reading:
Type and images unexposed; background exposed.
Right reading with the media emulsion side up.
Negative Wrong Reading:
Type and images unexposed; background exposed.
Right reading with the media emulsion side down.
Autocentering: Use this function to automatically position the image
within the media width. The choices are center or flush left.
Units of Measurement: Use this function to select the English (inches,
feet, etc.) or metric units of measure.
Processor Timeout: For use with the on-line processor. Use this
function to set the auto cut time delay after the last job. When the
delay period ends with no activity at the imagesetter, the last job is
advanced, cut, and fed to the processor. Set this value to 0 to shut it
off. Shorter timeout settings increase the amount of media wasted.
Note: Be careful not to set the Processor Timeout too short (i.e., 2
or 3 minutes). If you set it too short, the timeout may expire
before the next job is sent from the RIP, wasting 4-5 in. of media
between each job.
Advertisement
Table of Contents
