AGFA SelectSet Avantra Series Operating Manual page 119

27 Processor Alarm Signal
The OLP is reporting an alarm. This message appears as
an overlay on the screen that is currently displayed on
the imagesetter control panel.
The imagesetter will finish the current job, but will not
image another job or advance media until you correct
the error at the processor.
Check the alarm indicator LEDs on the processor
control panel. For more information, see the documen-
tation that comes with the SelectSet Avantra OLP.
After you correct the error at the processor, the image-
setter automatically resumes operation. This may take a
few minutes.
28 Hardware Error
Reset. If the error persists, call for service.
31 Input Side Punch Jam
Reset and retry the command. If the error persists, call
for service.
32 Carriage Position Error
?
The system detected a problem with the carriage while
imaging.
Reset. If the error persists, call for service.
Diagnostic and Error Messages 4–9