AGFA SelectSet Avantra Series Operating Manual page 156

3. Remove the front light shield, located behind the top and middle
access panels, from the cutter area.
To release the panel, loosen the three screws on the front of the
panel. Slide the panel out and then up to remove it from the
imagesetter.
4. Lift out the punch tray, empty it and then replace it.
5. Replace the front light shield.
Insert the front light shield into the imagesetter by sliding the flat
top piece underneath the cutter platform. Tighten the three screws.
6. Replace the top and middle access panels.
Insert the top and middle access panels by attaching the knobs to
the latches inside the imagesetter.
Imagesetter Maintenance 5–13