Table of Contents
Advertisement
Overriding Error 44: Cut Not Allowed
When you press Cut in the Utilities screen, the imagesetter checks to
make sure that at least 6 inches (15 cm) has been fed past the cutter.
Message 44, Cut Not Allowed, appears if not enough media has been
fed.
You can override this message and get the imagesetter to make the cut
without advancing media by performing the following procedure.
To override error 44:
1. Go to the Utilities screen.
2. Press Cut, then Accept.
3. When message 44 appears, press Pause. You return to the Utilities
screen.
4. Immediately press Cut, then Accept again.
Note: Use this override only if you are absolutely sure that at least
6 inches (15 cm) of media is past the cutter. If the cut produces a
sliver of media less than 6 inches long, you may have trouble
removing it.
Diagnostic and Error Messages
4–27
Advertisement
Table of Contents
