AGFA SelectSet Avantra Series Operating Manual page 128

57 Processor Error
The on-line processor is reporting an Input Jam, an Exit
Jam, or a Motor Overload error.
Remove the top cover of the processor. Check for media
near the input rollers. If media exists, push it through
the rollers and then reset the processor. If the media
does not finish processing, remove it and close the
cover.
Clear the error and check the on-line processor control
panel. For information on the media processor, see the
documentation that comes with the SelectSet Avantra
OLP.
The imagesetter will abort the current job and will not
image another job or advance media until the processor
error is cleared.
58 No Processor Communication
The on-line processor is not communicating with the
imagesetter.
Check the processor to make sure that it is turned on
and that the cables are connected.
4–18 SelectSet Avantra Series Control Panel and Operating Guide