Correcting Error 80: Bridge Is Not In Light Mode - AGFA SelectSet Avantra Series Operating Manual

4–28 SelectSet Avantra Series Control Panel and Operating Guide

Correcting Error 80: Bridge Is Not In Light Mode

Lifting the bridge while it is in heavy mode can be dangerous if the
bridge foot is attached. Therefore, when you attempt to lift the bridge,
the system checks to see if the bridge foot is attached and, if it is
attached, if the bridge is still in heavy mode.
If the bridge is in heavy mode and its bridge foot is attached, an alarm
beeps and the error 80 icon appears on the control panel. The alarm
continues to beep until you lower the bridge. The error 80 icon
remains on the control panel until you press Pause.
Perform the following procedure to correct error 80:
1. Lower the bridge and press Pause to display the Pause screen.
2. Press Utilities to go to the Utilities screen.
3. Press Bridge/Shuttle Weight and press Accept. The Accept button
flashes.
4. Press Accept a second time to start the shuttle motor. You will
hear the shuttle motor running as the bridge weight is shifted to
the back of the bridge. The shuttle motor is located in the back
corner at the top right side of the bridge.