Media And Operator Errors; Unloading Media Using The Utility Screen - AGFA SelectSet Avantra Series Operating Manual

4–26 SelectSet Avantra Series Control Panel and Operating Guide

Media and Operator Errors

This section contains detailed procedures for unloading media using
the Utilities screen and for correcting some special error conditions.

Unloading Media Using the Utility Screen

Perform the following procedure to unload media using the functions
in the Utilities screen:
1. Go to the Utilities screen.
2. If there is media in the take-up cassette, press Cut, then Accept to
cut it.
3. Rewind media back into the supply cassette. Press Reverse Feed,
then Accept.
4. Remove the supply cassette.
5. Remove any media that was bent or crumpled by the carriage
shield (Avantra 20/25) or shroud (Avantra 30/36/44). Pull one to
two feet (30 to 60 cm) of media out of the supply cassette, cut it
off, and discard.
6. Put the supply cassette back into the imagesetter.
7. Go to the Pause screen and load the supply.
8. Retry the original operation.
If you cannot unload the media or the error persists after following
this procedure, open the imagesetter and try to free the carriage. See
the Troubleshooting Media Jams chapter in this user guide.
If you cannot correct the problem, call for service.