Table of Contents
Advertisement
Chapter 2 Installing Your Product
2.1 Plugging in Signals
Connect signals to the product (ensure all devices are powered off first). Tighten connector
screws/locks where provided.
For connector protection and for additional cable support this product is fitted with protection
frames on either side of the device. For cable support use cable ties to attached to the protection
frames to avoid stress on signal connectors.
2.2 Plugging in Main Power
Connect IEC cable to device and plug into wall socket. Turn on power at wall socket.
2.3 Turning on Your Product
Turn the power switch on the rear of the product to the ON position.
OLED display will show as below, completing initialization before loading last settings and
input/output configuration.
On delivery, DVI1 will be the default input signal at 1920x1080@60Hz, and the output format is
defaulted to 1920×1080p@60Hz.
13
D2
User Manual
Advertisement
Table of Contents
