Connecting To An Ethernet Network - RGBlink D Series User Manual

Chapter 4: Controlling Your Processor Remotely

4.3 Connecting to an Ethernet Network

To realize LAN remote control need to build up a LAN platform, include the following:
One computer (Laptop or computer, used to do remote control which installed windows control
software in the computer).
One router (Better to have wireless function which may realize WEB control cross different
platform; without wireless function is available but only realize cable remote control. No
limitation for router's model and brand, such as VPN router model: Netcore 255 or 266; Volans
VE 760W or 982W).
One D2 processor (as long as the router's network ports can connect to, user can place multi
pieces of D2).
The operations are as follows:
Step one: LAN physical connection. Connect D2 and router with network cable, then connect
computer and router with network cable also, use the LAN port of router, WAN port is used for
connecting to outer net. Sketch map as below:
Step two: IP address setting (processor's default IP address is 192.168.0.100)
Firstly change computer's local connection to "automatically getting the IP", showed as below:
Secondly refer to router's instruction (user manual, specification), and find out router's default
network segment.
If router's default network segment is 192.168.0.1, then it is same to processor IP address
57
D2 User Manual