Table of Contents
Advertisement
Chapter 4: Controlling Your Processor Remotely
Finally, select Ethernet or USB connect, click "Ok", and finish connecting.
The green square in the bottom right means the connection is successful, white red is not.
4.1.2 Use
Image Toolbar
Show the image information, including resolution, channel, position, size and the signal. The
image size will be changed when set the parameters.
Signal Select
Click the signal icon, and the output image will be switched to the selected signal.
Scale
Select Channel A or Channel B, and scale the image by adjusting X, Y, Width and Height according
to actual need. Click "Set" after finish.
Mode
Click "Mode", and enter to the interface as below. D2 supports Std mode, PIP Mode, Dual 2K
Mode, Switcher Mode and Split Mode. User should select Std Mode before choose PIP Mode, or
it will not be shown on the interface.
44
D2
User Manual
Advertisement
Table of Contents
