Table of Contents
Advertisement
Push the signal button, and the signal will be switched to the output.
For example, the [SDI1] button light is on, it means the signal of output is SDI1, if user needs to
switch to VGA signal, push the [VGA] button, and the signal will be seamless cut or fade in fade
out to the output. User can adjust the switch speed in <Trans Time> option in <Transition>by
pushing the [MENU] button.
PIP Setting
Enable the PIP function
D2 supports seamless switch in single image and double images.
Push the [PIP] button, the button light is on, and enable the PIP function.
Select the signal in PIP
D2 can output two same or different signals to the output, the settings are as follows:
1. Push the [PIP] button, and enable the PIP function.
2. Push the [SCALE] or [DIMMER] button, select <Layer Select>, and push the rotary knob to
confirm. (User can also select <Layer Select> in <Input> or <Output> option by pushing the
[MENU] button.
3. Turn the rotary knob, and select main or sub image.
4. Select the signal, and the selected image will be switched to this signal.
Scale Setting
1. Push the [SCALE] button, and enter to the scale function menus.
2. Adjust the H size, V size, H/V size, H pos, V pos and scaling mode by turning the rotary knob or
number buttons.
3. If image quality distorts by improper operation, it can be recover by reset.
Image Size Setting
1. Push the [MENU] button, and enter to the menu items.
2. Turn the knob, and select <Input>, push the knob to confirm.
3. Turn the knob, select <Sizing Adjust>, push the knob to confirm.
4. Adjust the H size, V size, H pos V pos, and mask top, bottom, left and right of the image by
turning the rotary knob or number buttons.
5. If image quality distorts by improper operation, it can be recover by reset.
D2
Note
Note: PIP Setting is applied to Standard Mode.
Note
In PIP mode, user need to select the image that to set
in <Layer Select> option before setting.
User Manual
Chapter 3: Using Your Product
28
Advertisement
Table of Contents
