Table of Contents
Advertisement
Chapter 2 Installing Your
Product
2.1 Plugging in Signals
Connect signals to the product (ensure all devices are powered
off first). Tighten connector screws/locks where provided.
2.2 Plugging in Main Power
Connect IEC cable to device and plug into wall socket. Turn on
power at wall socket.
2.3 Turning on Your Product
Turn the power switch on the rear to ON position.
TST screen shows as below，meanwhile the device enter
initializing state after that，the device will load the previously
saved setting. On delivery, the default input is HDMI at
resolution 1920x1080@60.
C1US
INPUT: HDMI
NO INPUT
OUTPUT:1920x1080@60
VER:1.38
User Manual
15
Advertisement
Table of Contents
