Table of Contents
Advertisement
After setting, turn the rotary knob and select <Connect Type> according to actual connection
mode. D2 support 8 kinds of connection modes, they are
and
respectively.
->Connect Type
Save to receiver after choose the connection mode, observe the display screen and make sure
if display image is correct. If wrong, change the connection types. Then connect the Port D or
Port U of One Sending Card to LED Screen is finished.
(9) The setting for port D is same as the above setting.
Rendering is as follows:
2. Connect the Port D and Port U of One Sending Card to LED Screen
(1) First, make sure the device is in normal operation.
(2) Select the input source, for example, DVI.
(3) Connect one cable to Port D, the other one to U.
(4) Connect Port U to LED screen, the settings are same as Step 4 to Step 8 of "Connect
the Port D or Port U of One Sending Card to LED Screen".
(5) Connect Port D to LED screen, the settings are as follows:
D2
Height
Port Offset X
Port Offset Y
User Manual
Chapter 3: Using Your Product
,
,
,
,
,
120
0
0
>>
,
36
Advertisement
Table of Contents
