L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 56

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
6. Lower the array until ARRAY#2 is totally placed in the tray and the front rigging points between ARRAY#2 and
ARRAY#1 are in contact.
7. Disconnect the front rigging points between ARRAY#1 and ARRAY#2 as follows:
a. Remove both KARA#4 front top link R-BLP.
b. Slightly raise ARRAY#1.
c. Remove both KARA#3 front bottom link R-BLP, and re-insert them into the bottom storage holes.
d. Rotate both KARA#4 front arms down and re-insert both R-BLP into the top storage holes.
a.
Figure 57: Front rigging point disconnection between ARRAY#2 and ARRAY#1
8. Push ARRAY#2 away from the rigging location and put the flight-case lid on.
9. Lower the array to a height for which the angle arms of ARRAY#1 are comfortably reachable and set the angles
to 0° by applying step 2.
10. Place another empty KARA flight-case at the rigging location, remove the lid, and place the tray beneath
ARRAY#1.
Pay attention to the tray position: both inner slopes must be inclined upwards from front to rear
(see Figure 55).
WARNING
11. Lower the array slightly higher than the tray.
K1_RM_EN_2-0
® ® ® ®
system system system system
b.
KARA#3
KARA#4
w w w . l - a c o u s t i c s . c o m
c.
d.
54 54 54 54