L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 31

5. Detach the rear rigging points between TOWER#1 and
TOWER#2 as described below:
a. Arrange both K1-CHARIOT front wheels towards interior as it
is shown in Figure 24.
This operation will avoid instability when the
wheels are in contact with the ground.
WARNING
b. With 3 people (one manipulating the hoist controller and two
on both sides of the array grabbing the bottom handles of
TOWER#2), pull backwards while lowering the array until
both K1-CHARIOT front wheels touch the ground.
Stop lowering the array at the exact moment
when both K1-CHARIOT front wheels touch
the ground so as to avoid putting too much
stress on the K1-CHARIOT wheels.
CAUTION
c. Remove both rear R-BLP of enclosure#5 (see Figure 24) and
put them back in their storage locations.
d. Pull back both rear arms of enclosure#4: they should lock
back into the enclosure.
The front rigging points must remain
attached to prevent the bottom TOWER from
falling.
WARNING
Figure 24: Detaching rear rigging points
K1_RM_EN_2-0
c.
d.
L
w w w . l - a c o u s t i c s . c o m
#5
L
#4
L
#3
L
#2
L
d.
#1
L
L
29 29 29 29