Rigging And Safety Requirements - L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
9.2

Rigging and safety requirements

Two-point unbridled hang must be performed off the central bar using both K1-BUMP external shackles with a spacing
of 1.2 m/4 ft. At the same time, both internal shackles act as safety points (see Figure 66).
The rack stabilizer must be used when LA-RAK touring racks are mounted on the K1-BUMP (see Figure 67 and
[6.1.2]).
Up to 24 K1 and/or K1-SB enclosures, 4 LA-RAK touring racks, and corresponding cable set can
be flown as a vertical line source array using the K1-BUMP flying structure.
ALWAYS secure a flow array using two safety slings.
ALWAYS refer to the mechanical data and warning indications provided in SOUNDVISION software
WARNING
(Mechanical Data section) to verify the mechanical conformity of the system before installation.
Safety slings
Motor rigging
chains
External shackles
(rigging points)
Internal shackles
(safety points)
Figure 66: K1-BUMP's rigging and safety points
K1_RM_EN_2-0
® ® ® ®
system system system system
w w w . l - a c o u s t i c s . c o m
Rack stabilizer
Open front door
Figure 67: Flying K1-BUMP with LA-RAK
62 62 62 62