Array Removal - L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
6.4.3

Array removal

All along the procedure:
STRICTLY follow the sequence of the successive steps.
SYSTEMATICALLY ensure that each BLP is fully inserted.
WARNING
For clarity purposes the loudspeaker cable removal procedure will not be described.
The loudspeaker cables will not be represented on the figures.
CAUTION
1. Lower the array to a height for which the angle arms of ARRAY#2 are comfortably reachable.
2. With 2 people working simultaneously on each side of ARRAY#2, set the inter-enclosure angles to 0° as follows:
a. While grabbing the back handle of KARA#6, remove the rear top R-BLP of KARA#6.
b. Rotate KARA#6 so as to align the cursor of the angle arm with the 0° angle value.
c. Secure by re-inserting the R-BLP into angle hole 0°/2°/4°.
d. Repeat for KARA#5.
KARA#1
KARA#2
ARRAY#1
KARA#3
KARA#4
ARRAY#2
KARA#5
KARA#6
K1_RM_EN_2-0
® ® ® ®
system system system system
Figure 54: ARRAY#2 inter-enclosure angle setting
w w w . l - a c o u s t i c s . c o m
d.
c.
L
a.
L
L
b.
L
0°
L
52 52 52 52