L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 23

a.
L
Figure 16: Attaching K1-BUMP to TOWER#1 (motor hooks not represented)
7. Verify that each enclosure of TOWER#1 is attached to the enclosure above and (if necessary) pre-select the
angles as described below (see also Figure 17):
a. Ensure that both rear and angle arms are attached to the enclosure above.
ALWAYS check that all BLP are attached between enclosures in the TOWER.
ALWAYS check that all rear arms are attached by making sure that NO yellow stickers
located on the rear arms are visible.
WARNING
b.
Select the "variable" setting by pulling on the angle unlocking latch until a click is heard.
Check that the "variable" setting is selected on each latch by making sure that a yellow sticker
is visible.
IMPORTANT
c. Pre-select the desired angle: remove the R-BLP, hold it facing to the desired angle hole, and slide the angle
arm until the R-BLP enters and locks.
Note: One interest of the TOWER method is that the inter-enclosure angles can be pre-selected
beforehand.
In that case the user must strictly follow the order in which the TOWERS have been
planed to be rigged.
WARNING
K1_RM_EN_2-0
b.
L
b.
L
w w w . l - a c o u s t i c s . c o m
b.
REAR identification plate
L
21 21 21 21