L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 17

3. Secure the LA-RAK to the K1-BUMP :
a. Turn a spring-loaded safety and slide in the coupling bar along the rails until the safety has returned to
locking position (a click is heard).
b. Repeat for the second coupling bar.
.
b
4. If necessary, install a second LA-RAK onto the second 2-rail template by repeating steps 1 to 3.
The LA-RAK touring racks must be arranged so as to properly balance the K1-BUMP's centre of
gravity. Therefore, if only two racks are used each one must be placed directly onto the K1-BUMP
(see Figure 10).
WARNING
Figure 10: Rigging a second LA-RAK to the K1-BUMP (dos and don'ts)
K1_RM_EN_2-0
a.
Figure 9: Rigging a first LA-RAK to the K1-BUMP
w w w . l - a c o u s t i c s . c o m
b.
REAR identification plate
15 15 15 15