K1
K1
K1
K1
reference wst
reference wst
reference wst
reference wst
RIGGING PROCEDURES
RIGGING PROCEDURES
RIGGING PROCEDURES
RIGGING PROCEDURES
VERSION 2.0
14. Disconnect the rear rigging points between the KARA-DOWNK1 and the K1 as follows:
a. Hold KARA#1 and remove both rear R-BLP from the bottom K1.
b. Rotate KARA#1 downwards so as to align the rear rigging points between KARA#1 and KARA#2, and insert
both rear bottom link R-BLP on KARA#1.
c. Re-insert both rear R-BLP on the K1.
a.
L
Figure 60: Rear rigging point disconnection between KARA-DOWNK1 and K1
15. Remove ARRAY#1 from under the K1 array.
16. Remove the KARA-DOWNK1 from ARRAY#1 as
follows:
a. Remove the 4 R-BLP from the KARA-
DOWNK1.
b. Lift the KARA-DOWNK1 up and remove it from
ARRAY#1.
c. Re-insert the 4 R-BLP on the KARA-DOWNK1.
Figure 61: Removing KARA-DOWNK1 from
K1_RM_EN_2-0
® ® ® ®
system
system
system
system
b.
ARRAY#1
w w w . l - a c o u s t i c s . c o m
c.
L
b.
L
56
56
56
56