L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 50

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
4.
Attach a KARA-DOWNK1 on top of
ARRAY#1 as follows:
a. Remove the 4 R-BLP from the
KARA-DOWNK1.
b.
Place the KARA-DOWNK1
above ARRAY#1 with studs
oriented upwards and long ones
at the back.
c. Lower the KARA-DOWNK1 so
that the KARA#1 rigging arms
pass through the 4 slits and
secure by re-inserting the 4 R-
BLP.
Figure 46: Connecting KARA-
DOWNK1 to ARRAY#1
5. Raise the K1 array slightly higher than the KARA-DOWNK1 and place ARRAY#1 beneath it.
6. Connect the rear rigging points between the K1 and the KARA-DOWNK1 as follows:
a. Remove both rear R-BLP from the bottom K1 and let them hang.
b. Remove both rear link R-BLP between KARA#1 and KARA#2.
c. Rotate KARA#1 upwards so as to align the rear rigging points between KARA-DOWNK1 and K1, and attach
them by inserting both rear R-BLP on the K1.
a.
L
Figure 47: Rear rigging point connection between ARRAY#1 and K1
K1_RM_EN_2-0
® ® ® ®
system system system system
Short stud
b.
L
w w w . l - a c o u s t i c s . c o m
c.
Long stud
c.
48 48 48 48