L-Acoustics K1 REFERENCE WST SYSTEM Rigging Procedures page 26

K1 K1 K1 K1
reference wst reference wst reference wst reference wst
RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES RIGGING PROCEDURES
VERSION 2.0
9. Raise the TOWER#1 until the K1-CHARIOT wheels reach 0.3 m/1 ft eight.
Note: As the array is raised all angle latches should subsequently take their locking position and a "shlack" noise
should be heard.
ALWAYS check that all inter-enclosure angles have reached their locked position by making sure
that NO yellow stickers located on the angle locking latches are visible (except on the bottom
enclosure).
WARNING
10. Remove the K1-CHARIOT from TOWER#1 as described below:
a. Remove both front R-BLP from the bottom enclosure while holding the K1-CHARIOT.
b.
Remove both back R-BLP and remove the K1-CHARIOT.
c. Place the four R-BLP back into their storage locations on the bottom enclosure.
c.
L
a.
L
K1_RM_EN_2-0
® ® ® ®
system system system system
c.
L
b.
L
Figure 19: Removing the K1-CHARIOT
w w w . l - a c o u s t i c s . c o m
24 24 24 24